Foxtrot Legacy v12.2.4 emulator selection in PREFERENCES not saved in NON-PERSISTENT mode in Windows 11 operating system after a machine workstation re-boot or re-start. We checked C:\ProgramData\Foxtrot Suite\FTSessionControl.CFG file but found no settings to default emulator selection in PREFERENCES-DEFAULT USER display. We checked REGISTRY SETTINGS for HKEY_CURRENT_USER and HKEY_LOCAL_MACHINE but did not find any FOXTROT SUITE settings. We check C:\users\<username>\AppData\Local\ and C:\users\<username>\AppData\Roaming\ but did not find any FOXTROT SUITE settings. However, we do observe the emulator selection in PREFERENCES is retained as long as the user does not logoff or reboot or re-start the machine workstation. Does this mean the settings are set and stored in Foxtrot ADMINISTRATOR? If so, what do we need to do on Foxtrot ADMINISTRATOR to fix this issue?
Foxtrot Legacy v12.2.4 emulator selection not saved in NON-PERSISTENT mode on Windows 11 operating system
+1
+11- Nintex Employee
Hello Alvin,
I suggest that you open a Support case by sending the above message to Support@nintex.com. We are going to need a lot more information from you and the case is a faster way to communicate.
We will need to know what type of emulator you are using.
Is the emulator 32 bit?
What error message you are receiving, if any.
I do not believe this has anything to do with the registry and as far as I know the settings are not save in Foxtrot Admin.
Kind regards,
Michelle
Nintex Support Engineer II
+1Nintex Support Case # 00780094 has been submitted [ ref:_00D90q6Cb._500fuj80qd:ref ] as recommended with details requested on Foxtrot Legacy (32-bit) information.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.