Skip to main content
Nintex Community Menu Bar

K2 BP SP1 Studio Issue - TOOLBOX empty

  • January 4, 2008
  • 4 replies
  • 26 views
Forum|alt.badge.img+2

Was able to /nearly/ get a successful upgrade to K2 BP SP1.


When create a new K2 Workflow project or open an existing one, I get an empty toolbox.


All I get is the General header, with "There are no usable controls...".


This includes changing the context of what is open and/or selected.


Help aoppreciated!

    4 replies

    Forum|alt.badge.img+8
    • Nicolas1
    • January 4, 2008
    I had a similar problem at the time of Hotfix 2.01... The solution was to run the configuration wizard again on the computer where VS 2005 is installed, and reboot it. I don't know what file is really modified during this re-configuration, but it solved the problem.
    Forum|alt.badge.img+2
    • scottforce
    • Author
    • January 4, 2008

    Thanks for the reply. Tried re-running configuration manager and reboot.


    Still same. HELP please!

    Forum|alt.badge.img+2
    • scottforce
    • Author
    • January 4, 2008

    Seek and ye shall find ---


    I was looking for ANYTHING that would prove to be a solution, and there's a context menu item found by right clicking in the empty toolbox area calld "Reset Toolbox."


    That did the trick. Thanks for your earlier recommendation, too.


    ** Further research showed that this likely occurred when the original crashes were occurring (see post # 20893)


     

    Forum|alt.badge.img+11
    • DavidL1
    • January 4, 2008

    Try right-clicking on the toolbox in VS and select 'Reset Toolbox'.

    Sidebar Buttons
    Nintex Community Home Contact Nintex Support Email Nintex Community Check Nintex Status
    Terms & ConditionsAccessibility statement