K2 BlackPearl Service Stops, doesn't want to resume, but works in console mode / Event ID 1056

Forum|Forum|16 years ago
September 30, 2009
5 replies
22 views

+2

courtina

Hi all,

Just upgraded my dev platform from 4.8210.2.0 to 4.8210.3.0 (with package 45) and added 535 updates too.

Everything ran fine till now : the K2 Service stops with the following event error

"12166503","2009-09-30 06:20:03","Error","","1056","","SourceCode.Hosting.Server.Runtime.HostServerEngine","1056 Logging Framework Error, MsgID=1056 (Message Not Found)","system","172.16.XXX.XXX","<servername>:d:program filesk2 blackpearlHost ServerBin","12166503","0b65cec2db524ebe9af516fe7a1ae0e8",""

Note : the K2 Server runs fine when launched in console mode, using the same service account...

Thanks in advance for your ideas,

Regards,

Antoine

+14

Vernon
Scout
Forum|Forum|16 years ago
September 30, 2009

Is the license you are using a Development Licence? If so please note since the release of Kb000450 and 4.8210.3.0 the Development license can't run as a service, it can only run in console.

So if you are referring to the service gets stopped, this is normal behaviour, just run the K2 Server in console mode. Please refer to : http://kb.k2workflow.com/articles/kb000473.aspx

Hope this helps

Vernon

Like

J

+6

jan2
Forum|Forum|16 years ago
September 30, 2009

Hi Vernon,

Thanks for your answer. The link you provide, give us a "page could not be found" message and I can't find a revelant KB article corresponding to this, neither in the 450 release note, neither in the K2 blackpearl installation guide.

Thanks for your help