BlackPearl Instalation guidelines

Technically I don't think you need to uninstall K2 2003 if you don't want, however you'll want to make sure that the K2 2003 service is not running (disabled) as by default it, and blackpearl use port 5252 for workflow processing.  However, if you have no need for K2 2003, you should be able to uninstall it before installing blackpearl.

As for blackpearl prereqs, I would recommend you refer to the K2 blackpearl Getting Started Guide available for download on the portal (https://portal.k2workflow.com/downloads/bp/Default.aspx).  It is highly recommended that this be read for pre-requisites as well as installation instructions.

HTH.

Hi Bob,

Thanks for quick reply.I will start to install BlackPearl after reading that instruction guide.

Regards,

Sureshr

In order to provide a feedback regarding K2.net 2003 and Blackpearl on the same server, I can reassure you: if you change the default port when you configure Blackpearl (as implied by Bob), the both products will work perfectly without having to deactivate one of them.

Hi,

If you're going to install K2 [blackpearl] have a look at this post, it may help.

 Cheers,

Seb

http://k2underground.com/blogs/seb/archive/2008/01/25/k2-blackpearl-server-roles-component-installation-a-disambiguation.aspx