cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Not applicable

Show and hide panels and have the form readjust

Jump to solution

I'm building a help section within a form of ours.

This section is hidden and can be toggled via a 'Risk Help' button.

In this help section there is a set of helper panels. Each with a button that will show it's corresponding panel.

Nintex01.PNG

But when building this section, the form freaks out and leaves a heap of while space below. Now each panel is of different heights, and one of these panels fits this height but I want this section to rearrange the white space on each click. Instead of leaving a gaping hole.

If this is too difficult for nintex to grasp, I'd prefer the form to act like this:

Nintex02.PNG

And to keep the section the same height, have the longer panels use scroll wheels. But I'm not sure how to get nintex to do this...

I've attached the form in it's current state below.

Labels: (3)
0 Kudos
Reply
2 Replies
hcait
Nintex Newbie

Re: Show and hide panels and have the form readjust

Jump to solution

Hi Michael,

Make sure that all these labels are in its own panels and hide the panes based on the selection. Panels do adjust the space and height automatically and works well. I can see that none of them are inside any panel. could you give that a try, may be, that might help.When placing the Panel on design surface, just place it below one another, pretty sure that the height will get adjusted based on your rule to hide other panels.

Reply
Not applicable

Re: Show and hide panels and have the form readjust

Jump to solution

Thanks Shaju,

I ended up not added a heap of panels and set allowed the labels to reside in their settings.

By stacking them on top of one another and a bit of Nintex fiddling I was able to get it to work.

Cheers.

0 Kudos
Reply