cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Nintex Newbie

Error in CA when I click on Action Settings

Jump to solution

Click Nintex Administration>> Workflow environment>> Action Settings

Result error message

Sorry, something went wrong
Ribbon <Tab> node must have a <Scaling> subnode.
Version is the new release for SharePoint 2016 (Latest release of SharePoint 2016 patching Jan 2017 release)
Single server for development
Workflow only to be installed. 
version: 4.1.1.0
Labels: (1)
0 Kudos
Reply
7 Replies
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

Hi James,

could you go to Central Admin -> System Settings -> Manage Farm Solutions and check if all solutions have been installed correctly?

It should look like this:

If so, could you also check if the database is installed correctly? Go to Nintex Administration -> Database Management

There should at least be one database shown for Workflow.

Kind regards,

Enrico

0 Kudos
Reply
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

All Solutions are installed.  We did not install forms as we do not use the form part of Nintex. 

I even deleted and recreated the nintex db for workflows same result.

0 Kudos
Reply
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

Farm Solutions installed

0 Kudos
Reply
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

I googled a bit and found that the error could be caused by a missing SharePoint feature, that needs to be active on the site

Error in Central Administration: Ribbon <Tab> node must have a <Scaling> subnode. - SharePoint Stack... 

But I think in that case you would also face the error on different screens in Central Admin. You could at least check if the feature is activated though.

I would give the installer another try, reinstall everything and if the error is still present contact Nintex Support to see if the error is known.

Kind regards,

Enrico

Reply
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

I fixed this by going to CA>> Site Settings>>Site Features and turned on the Nintex Admin feature set.

Thanks,

James

View solution in original post

Reply
Highlighted
Not applicable

Re: Error in CA when I click on Action Settings

Jump to solution

Hi, ‌, shall we mark your last reply correct, then and close the loop on this question?

0 Kudos
Reply
Highlighted
Nintex Newbie

Re: Error in CA when I click on Action Settings

Jump to solution

Yes please mark as correct.

Sent from my iPhone

Reply