+8For the first time, I am using a Signature form control to capture a signature, which I then want to place on a generated PDF document.
I’ve done it successfully, but with one problem: the signature image on the generated document is much too large.
I was looking at this thread, where
But I don’t understand what this means, “use a picture and name it using the tag.” Use a picture how? What exactly am I supposed to do?
Any help is much appreciated.
Best answer by brent_read
Hi
The basic methodology on this is to put a picture into the document that is the size you’d like the picture to be added as. After that select the Picture format>Selection Pane in the ribbon. Should look like this:
Then in the Selection pane you should see the Selection Pane with a name for the picture:
If you Rename the name (Picture 2 above) to the tag from the document tagger you should get the image in the document sized to fit the picture in the template.
Hi
The basic methodology on this is to put a picture into the document that is the size you’d like the picture to be added as. After that select the Picture format>Selection Pane in the ribbon. Should look like this:
Then in the Selection pane you should see the Selection Pane with a name for the picture:
If you Rename the name (Picture 2 above) to the tag from the document tagger you should get the image in the document sized to fit the picture in the template.
+8Thanks,
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
