ERefat
Forms Fledgling

Worfklow wont start automatically

Jump to solution

I have the same issue for Nintex O365 workflow everything was going smooth and nice tell yesterday

the all process suddeny stopped from running automatically based on condition the process usally start automaticully for modify or created today user reported that his process wont start

any clearificationfor sharepoint online Office 365

0 Kudos
Reply
8 Replies
Michel
Process Pupil

Re: Worfklow wont start automatically

Jump to solution
I once had the same issue, reconfiguring the start conditions seemed to work at that time. Could you try to remove the start condition, publish the workflow and reconfigure the starting conditions?
0 Kudos
Reply
ERefat
Forms Fledgling

Re: Worfklow wont start automatically

Jump to solution

I had created new list with sample workflow sat with condition and without,

however, it's working fine for non conditional. but even I reconfigured the created conditions it's wont to start

0 Kudos
Reply
Janet
Design Dabbler

Re: Worfklow wont start automatically

Jump to solution

We are having the same issue on all conditional workflows since Friday.  I have contacted support about it.

0 Kudos
Reply
dottie
Forms Fledgling

Re: Worfklow wont start automatically

Jump to solution

We are also having an issue, all workflows with conditional starts are not working. There was an incident yesterday, and it says it's resolved, but not so sure that is true.

0 Kudos
Reply
akilrey
Nintex Observer

Re: Worfklow wont start automatically

Jump to solution

I am having the same issue, where the Nintex Workflows will not start, everything ran smoothly until this morning when no new items were being created. I tried to remove the starting conditions then reapply them as another comment suggested but that did not work either.

0 Kudos
Reply
SimonMuntz
Nintex Employee
Nintex Employee

Re: Worfklow wont start automatically

Jump to solution
0 Kudos
Reply
Michel
Process Pupil

Re: Worfklow wont start automatically

Jump to solution
Can you please confirm if the issue is resolved? According to the Nintex Status page, it should 🙂
0 Kudos
Reply
SimonMuntz
Nintex Employee
Nintex Employee

Re: Worfklow wont start automatically

Jump to solution
This issue was resolved.
0 Kudos
Reply