Skip to main content
Nintex Community Menu Bar

Multilingual control in K2 five version 5.3

  • February 10, 2021
  • 2 replies
  • 69 views
  • Translate
K
Forum|alt.badge.img+5

Hi,

Has anybody installed multilingual control in K2 5.3 version? while registering , I am getting error

“Searching assembly for control type definition...

Found 0 control type definitions”

 

Please guide me in resolving this issue.

 

Regards,

Kathija

 

    Did this topic help you find an answer to your question?

    2 replies

    K
    • KevinZ1
    • 37 replies
    • February 10, 2021

    Hi kathija,

    On previous posts, I found that following steps in the link below solves this problem.
    https://k2recipes.wordpress.com/2017/11/18/register-de-register-smartform-custom-controls/

    Please let me know if it helps you sort your problem out

    Regards,
    Kevin

    Translate
    K
    Forum|alt.badge.img+5
    • kathija
    • Author
    • Rookie
    • 14 replies
    • February 11, 2021

    Hi @KevinZ ,

    Thank you for the response, I had followed the same steps mentioned in the link to register the DLL in k2 five. but I was not able register the DLL successfully.

     

    Regards,

    Kathija

    Translate

    Reply


    Sidebar Buttons
    Nintex Community Home Contact Nintex Support Email Nintex Community Check Nintex Status
    Terms & ConditionsCookie Settings

    Cookie policy

    We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

     
    Cookie Settings