Skip to main content
Nintex Community Menu Bar
Knowledge Base

Dynamic Advanced Commands DAC Distribution System


Forum|alt.badge.img+3

Topic

 

Product version                            22.3 and higher
Components                            DAC

 

Instructions 

 

  • Nintex Dynamic Advanced Commands (DAC) are available for version 22.3.x and above.
  • The DAC installer includes the server and client version. The same installation file covers both options.
  • Choose the type of installation from the menu below: Client or Server. Then, follow the instructions below depending on the type of installation you choose. 
  • The DAC server version must be installed on the RPA server for distribution to work.
  • If Studio/Robot is installed on the RPA server, there is no need to install the client version.
  • After Studio/Robot installation, go to the Options page to start the DAC sync.

 
For Server Installation:

  • DAC should be installed immediately after RPA server is installed.
  • Installation path cannot be defined. It will always be installed in:

<Installed Drive>:\Nintex\installer-assets



 

  • After installation has been completed, a dynamic-commands folder will appear in the installer-assets folder in the installation directory.


 

  • Opening the folder, you will be able to see all applicable advanced commands and all of them are in .zip format. 


 

  • The actual folder which will be used for the distribution to the clients can be found in:

%ProgramData%\Kryon\ac\1\Approved
**The 1 in the above path represents the company ID of the tenant. If there is more than 1 tenant, you should see corresponding sub-folders matching the company ID of the respective tenants.
 



 

  • Go to %ProgramData%\Kryon\ClientsProxy and verify that the clients-proxy .dat files are present.
  • The frequency of the DAC sync can be configured from:

<Installed Drive>:\Nintex\config\prod\services\kryon-clients-manager-svc-default.json

For Client Installation (On Server)

  • There is no need to install DAC client edition on RPA server for client usage.
  • The DAC server edition should be installed before client installation.
  • Studio/Robot appSettings configuration for DAC folder should point to %localappdata%\Kryon\DynamicCommands
  • The first time Studio/Robot is launched, go to the Options menu and proceed to Advanced tab. Locate the section “DAC Updater Service”. Perform a first time sync manually and then set it to run the updater service automatically every 60 mins.
  • Check back in the %localappdata%\Kryon\DynamicCommands folder after some time to verify if the DACs are synchronized from the server.
  • Studio and Player will have their own folders to execute the DACs from.
     

For Client Installation (On Client Machines)

  • Installation of DAC is as per normal. It should be installed after Studio/Robot has been installed.
  • During installation, the option “Client” should be selected in the installer wizard.
  • Studio/Robot appSettings configuration for DAC folder should be automatically updated to the location where the DACs were installed.
  • The first time Studio/Robot is launched, go to the Options menu and proceed to Advanced tab. Locate the section “DAC Updater Service”. Perform a first time sync manually and then set it to run the updater service automatically every 60 minutes.

 

 

Translate
Did this topic help you find an answer to your question?

0 replies

Be the first to reply!

Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie Settings