Hi,
Ockert, Thanks for the reponse yesterday.
As a follow-up (because we couldn't get it working), is K2 supported on Domain Controllers (including the Workspace)? I haven't seen any literature that says it isn't (but my memory is neccesarily that good!). If so, what other steps can we follow to get IWA working the Domain Controller.
I suppose this problem would be covered by the K2.Net Maintenance support we purchased?
Cheers,
Charl
+11
Hi Charl,
Sorry for the delayed response. I was on leave for a while...
Have you managed to get this working? You should not have any trouble - we run demos and POCs on domain controllers all the time.
SOMETIMES, it is necessary to enable Kerberos authentication as described in KB article #123.
Regards,
Ockert
Sorry for the delayed response. I was on leave for a while...
Have you managed to get this working? You should not have any trouble - we run demos and POCs on domain controllers all the time.
SOMETIMES, it is necessary to enable Kerberos authentication as described in KB article #123.
Regards,
Ockert
Reply
View our Community Site Map
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.