Each workflow fails to start with error: Procedure or function 'CreateWorkflowInstance' expects parameter '@InstanceID', which was not supplied. Do you have any suggestions please? Thank you
Page 1 / 1
What build version?
Try installing the last version
Hi, we have got a problem on SP2010 server. Nintex Workflow 2010 (2.3.7.0)
It works well few hours ago.
We were installing a SP2013 on other server. Then I restore NWF2010db backup to new server and mapped in CA.
The SPcontent db was (read-only) for a while on SP2010 server so I think it might cause this issue?!
Thanks
May be, I 'd restart the server
I have tried, but with no effect.
Problem solved! I had to re-map config and content dbs in CA, however it looked correctly.
How?
CA - NWF Management - Database setup - Edit
Set SQLserver, dbname (check connect to existing) and OK
Same for content dbs (use add content database) and check "manage database mappings"
You might want to look at https://community.nintex.com/docs/DOC-1094 to find out why.
Reply
View our Community Site Map
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.