Nintex behavior is such that when I select OK it doesn't look like the workflow published. There is no version posted under the workflow name. Yet when I go to the list of workflows it shows it as published. Can you tell me what is going on?
What version of Nintex are you using?
Nintex Workflow 2013
© 2014 Nintex. All rights reserved.
Version: 220.127.116.11 - English
License type: Registered (Enterprise)
Software Assurance status: Current
Software Assurance expires: 9/8/2016
Jim Tucker, P.E., PMP
Project Information Management
Was this working before and now you're getting this issue?
If that's it, then have there been any customizations of the SharePoint environment recently?
I've never seen anything like this.
If you can't get to the bottom of it, please reach out to the Nintex Support team.
I attached the workflow to this reply.
Yes it was working. SharePoint 2013 has been re-installed on another server along with Nintex 2013.
I imported and published your workflow on my VM and did not get that pop up. I'm afraid I'm not sure what is causing that.
I'd definitely recommend you reach out to support to help get to the bottom of this.
Any update on this as I'm experiencing exactly the same issue.
Retrieving data ...