AnsweredAssumed Answered

All controls missing after Set a Condition control in Nintex

Question asked by ctoper11 on Aug 13, 2018
Latest reply on Aug 31, 2018 by emha

Just notices something very troubling in two of my workflows thus far. After the Set a condition control is used anything after does not appear. If you can see the two examples I attached after both of those Set a condition controls there is a lot more workflow to go but it just stops. Now when I actually go to edit the workflows all controls are there. But when fired those pieces are missing and if I bring up the workflow to manually fire they're also missing. Any ideas?


Thanks in advance