No ratings

Unable to Configure Tree Control


Unable to Configure Tree Control

This article was created in response to a support issue logged with K2. The content may include typographical errors and may be revised at any time without notice. This article is not considered official documentation for K2 software and is provided "as is" with no warranties.
This article has been archived, and/or refers to legacy products, components or features. The content in this article is offered "as is" and will no longer be updated. Archived content is provided for reference purposes only. This content does not infer that the product, component or feature is supported, or that the product, component or feature will continue to function as described herein.


When you have a view with a Tree control and you would like to configure the control using “Configure Data Source,” it does pop up within the Designer. However, it continuously loads up and constantly stays in this state.


No error is shown.


Duplicating the view does not work and also applying Fixpack 13 does not work here either, as seen on a previous KB article. 


This issue is resolved within Fixpack 24 for K2 5.1.
Labels: (1)
Version history
Last update:
‎05-19-2021 06:23 PM
Updated by: