cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Not applicable

"Run If" command executing multiple times

I have a simple query with a "Run If" statement that evaluates two conditions.  If the conditions are met the workflow then sends an Email and sets the Yes/No indicator field to No.

Each time I publish a new copy of the Workflow it sends the Email an additional time.  For instance Version 3.0 of the Workflow runs 3 times.

I referenced the Nintex Support answer located here: Workflow starting multiple times , which states to clean up older instances of the workflow.  This is wrong and does not work and clearly was not tested by the person posting the answer.  Very frustrating!

I also renamed the workflow and deleted prior named version, this too does not work.

I can't believe that I am the only person to experience this and yet could not find any information on Nintex Support other than one wrong post.

0 Kudos
Reply
1 Reply
Workflow Hero

Re: "Run If" command executing multiple times

so have you checked workflow settings on the list to "remove, block or restore a Workflow" and ensured that older versions are set to no new instances?

Accept as Solution Reply