I can't display the doc which launch my process through sharepoint in a smart form using K2DocAttachment...
What are mandatory properties to set and with which values?
thax
+8
Have a look at jacov's response in the following thread for the properties of the docattachment control:
http://forum.k2workflow.com/viewtopic.php?t=138
Are you using the standard AttachedDocuments XML datafield? Are you sure that the datafield that contains the document information is being populated correctly when the process is initiated?
http://forum.k2workflow.com/viewtopic.php?t=138
Are you using the standard AttachedDocuments XML datafield? Are you sure that the datafield that contains the document information is being populated correctly when the process is initiated?
+7
Ok, thanks, it works now... thank you!!
+7
eh eh
a little problem now...
When I loop in my file upload process,
during second cycle, K2DocAttachment displays two file which are the same instead of one...
and during any additional loop, I still get these two files...
it's a bit strange...
Does somebody knows why...?
a little problem now...
When I loop in my file upload process,
during second cycle, K2DocAttachment displays two file which are the same instead of one...
and during any additional loop, I still get these two files...
it's a bit strange...
Does somebody knows why...?
Reply
View our Community Site Map
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.