cancel
Showing results for 
Search instead for 
Did you mean: 
Workflow Hero

Nintex work gets stuck on pause

workflow runs normally sometimes but then get stuck on pause for 3 minutes at other times .. The snapshot shows the wk that has been stuck for over 21 hours on a 3 min pause.. how do i troubleshoot this

0 Kudos
Reply
1 Reply
Workflow Hero

Re: Nintex work gets stuck on pause

Restarting the Timer Service usually resolves the problem, although sometimes underlying problems cause the issue to come back and require restarting the TS again.   You can try and it and see if something resurfaces, and if it does, then you can start to dig deeper into the exact causes.

Thanks

Mike

0 Kudos
Accept as Solution Reply