cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
gohkh
Nintex Newbie

Nintex Hawkeye Beacon Within For Each Loop Problem

I have started to use Hawkeye Process Lens with Nintex Workflow for O365.

I have inserted a beacon within a For Each loop in my workflow as shown below:

The Beacon action is configured with 3 keys (Month, Expense Type, Amount):

After the workflow is run, I could see that the Log History action immediately before the beacon showed the workflow went through the loop twice, and the the data were correct:

I was expecting that the beacon to have captured 2 sets of data from the workflow instance. However, when I refresh the Process Beacons Table from Power BI desktop, I could only find 1 set of data during the last round the workflow went through the loop as follows:

What could have gone wrong? How should the beacons be configured to capture information for each round of the loop that the workflow goes through?

0 Kudos
Reply
1 Reply
alexv
Nintex Newbie

Re: Nintex Hawkeye Beacon Within For Each Loop Problem

I just experienced the exact some issue. The solution was to add a Pause for Duration (1 minute) action in the loop.

Nintex Beacon.png

0 Kudos
Reply