cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Nintex Newbie

List Lookup Control - Source List Reverts To -----Please Select – when ID connected to is set to a lookup column

This is how we initially configured a list lookup we left the ID connected to set to its default setting.

In new development we noticed that the lookup columns were no longer displaying the user’s selection.

We found guidance that indicated a non-default value must be selected for the configuration column ID connected to. Figure 2 below:

However, when we selected the lookup list column Vendor for connected to, the Selected List column reverted to its default value –Please Select – and triggered the warning message in yellow the Source List is required. When the connected to column is reset to Not connected we can see that the Source List configuration field is set to its default value. See below:

How can I configure the lookup control to save the user’s selected item and make it visible in the item’s row?

0 Kudos
Reply
2 Replies
Nintex Newbie

Re: List Lookup Control - Source List Reverts To -----Please Select – when ID connected to is set to a lookup column

Hi,

I had the same problem.
I did delete the List Lookup from the custom list and then re-created a new one.

Then went to nintex Form and the ID Connect To fiels does not show the error as you have explained.

0 Kudos
Reply
Highlighted
Nintex Newbie

Re: List Lookup Control - Source List Reverts To -----Please Select – when ID connected to is set to

18 months later, and I have the same issue. Why is the control insisting on a "Source List" property while hiding the field from me at the same time?

0 Kudos
Reply