Dondearie
Canvas Initiate

Unhide Panels

Jump to solution

I have a responsive form with a rule that hides all panels when the form is loaded and displays selected panels based on a dropdown choice, which works OK. However, i need another panel to be unhidden based on a dropdown choice (Yes or No) on the previous "unhidden" panel. I just cannot get my rule to work. Please, assist

0 Kudos
Reply
5 Replies
kunalpatel
Automation Master
Automation Master

Re: Unhide Panels

Jump to solution

@Dondearie ......ls your setup is as mentioned below:

 

  1. You have panel 1 which is hidden when the form is loaded
  2. You have a DD inside panel 1
  3. You have another panel 2 inside panel 1

If that's the setup then you can put a rule which will hide panel 2 if DD is nullempty or "No"

0 Kudos
Reply
Dondearie
Canvas Initiate

Re: Unhide Panels

Jump to solution

@kunalpatel below is my setup:

 

- I have 5 panels, 4 hidden at form load.

- There's a DD with 2 options in panel 1 (the only visible panel when the form loads) and depending on the option picked, Panel 2 or Panel 3 becomes visible.

- within Panel 2, I have another DD that should bring up Panel 4 if Yes is chosen or Panel 5 if No is chosen. This is the part I am unable to get to work.

 

thank you.

0 Kudos
Reply
kunalpatel
Automation Master
Automation Master

Re: Unhide Panels

Jump to solution

@Dondearie....try below approach:

 

  • Panel 1 always visible and DD1 in it has Yes/No choice
  • Rule for Panel 2 & 3: 
    • Hide Panel 2: or(isNullOrEmpty(DD1),equals(DD1,"Yes"))
      • Has DD2 with Yes/No choice
    • Hide Panel 3: or(isNullOrEmpty(DD1),equals(DD1,"No"))
  • Rule for Panel 4 & 5:
    • Hide Panel 4: or(isNullOrEmpty(DD2),equals(DD2,"Yes"))
    • Hide Panel 5: or(isNullOrEmpty(DD2),equals(DD2,"No"))

View solution in original post

0 Kudos
Reply
Dondearie
Canvas Initiate

Re: Unhide Panels

Jump to solution

Thank you so much, @kunalpatel. With the steps you gave, and some additional rules, I was able to get this working

0 Kudos
Reply
kunalpatel
Automation Master
Automation Master

Re: Unhide Panels

Jump to solution

@Dondearie ...could you please mark it as accepted solution then?

0 Kudos
Reply