Not applicable

Install Nintex English over the International Version

Jump to solution

Hello,

we have some costumers they have installed Nintex 2013 international version 3.0.8.0. Now we have established some problems with the international version.

Is it possible to change the version from international to the currently English version?

What are the correct and best steps to do this change?

Kind regards

Mario

Reply
2 Replies
aaron_labiosa
Novice

Re: Install Nintex English over the International Version

Jump to solution

Hi Mario,

Absolutely! Simply run the English installer on the server the same way you did the International version. The only differences between the two versions are in the assemblies themselves which will be replaced with the in place upgrade over to English.

Cheers!

Reply
christopher_whi
Nintex Employee
Nintex Employee

Re: Install Nintex English over the International Version

Jump to solution

Warning, this may require additional work to workflow designs!  

Going from English to (Same version or higher) International is supported. Going the other way, any workflow design with the international version of the designer may require you to redesign them again in English if they were designed in another language. Should any issue arise Nintex Support will recommend updating to the latest International build to bring both English and International binaries into alignment.

It is recommended that once you install the international build that you stick with it.

Reply