Multilingual control in K2 five version 5.3

  • 10 February 2021
  • 2 replies
  • 57 views
K
Badge +5

Hi,

Has anybody installed multilingual control in K2 5.3 version? while registering , I am getting error

“Searching assembly for control type definition...

Found 0 control type definitions”

 

Please guide me in resolving this issue.

 

Regards,

Kathija

 

2 replies

K

Hi kathija,

On previous posts, I found that following steps in the link below solves this problem.
https://k2recipes.wordpress.com/2017/11/18/register-de-register-smartform-custom-controls/

Please let me know if it helps you sort your problem out

Regards,
Kevin

K
Badge +5

Hi @KevinZ ,

Thank you for the response, I had followed the same steps mentioned in the link to register the DLL in k2 five. but I was not able register the DLL successfully.

 

Regards,

Kathija

Reply


View our Community Site Map

Nintex Community Sitemap
Terms & ConditionsCookie settings