+3
Have a WF in O365 and have tried several times to open this up and make edits but continue to get the following error:
Error opening a workflow. Cannot set unknown member 'NintexActivities.WorkflowXaml_b01f72cc_6e32_4ce3_9621_36d003d2e8e0.AuthUrl'.
Correlation ID: 7c0566d1-a096-4d78-a321-280582ca4fd2
Tenant ID: ba68103f-7f31-4fb1-b884-021506ec4922
Time (UTC): 2016-01-29 04:04:22
Please advise. Would like to get this resolved ASAP!
Thank you.
Mark -
+9
Hi Mark,
Did you try to remove the Nintex Workflow App from Site Content and reinstall it?
Regards,
Christophe
+7
Hi Mark,
I did have this same issue the other day but never really found out why, however I had been changing and deleting list columns used by the workflow.
I've been trying to replicate what I was doing to see if it'll break again but haven't managed so far, but I'll keep going and see if it's reproducible.
Jan
+3
Hi Christophe,
By removing nintex wf app from site content,do you mean deleting the app from my entire site? I ask because this site has 7 workflows build within it. Please advise as to what you are referring to and the process to complete the steps.
Thank you!
mark -
+3
Hi Jan,
This is about to go production so "no- there were no columns removed from this list". other ideas?
Thank you!
Mark -
+3
Please advise. This is somewhat of an urgent issue...
+11
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.